The International Association of Gay/Lesbian Country Western Dance Clubs

Dangle Specifications and Template

This page is for clubs preparing to host a convention and not for the general public, however everyone is welcome to read the page and download the template if they really want to do so.

---

Here is the new dangle template provided by the manufacturer:

DangleTemplate2006.ai (right-click and select Save Target As... or Save Link As...)

If you cannot open the Illustrator 10.0 file above, use this pdf version.

Clubs hosting conventions should use this template to create their dangle file NO LATER THAN THREE MONTHS prior to the convention.

Helen will provide each club with the address of where to send the dangle file.

The following instructions were also provided by the manufacturer:

I have attached a new dangle template. I added 1/32" to each side and used square corners. The reason I added the 1/32" is to allow for the blade width when we cut them down so we end up with .875" square. I also squared the corners so when we corner round the dangles no white will show incase our corner round does not match the artwork 100%. The yellow on the template would represent the very outside of your artwork, hence the image would bleed by 1/32" on all sides. The very outside of the black line represents the 7/8" finished dangle. Once we cut the squares then we corner round the corners.

Can you please send the dangle artwork sized to .94" square and we will cut it down from there? - thank you!